September 2006
3.3 STACK FEED-OUT BELT
[B] [C]
B478R523.WMF
1. Open the front door.
2. Pull out the jogger and stapler unit.
3. Remove the inner cover [A] (
4. Remove the sensor bracket [B] (
5. Remove the front guide [C] (
NOTE: When re-installing, make sure that the flat end of the shaft is against
the plate.
6. Remove the front panel [D] from the stays (
7. Remove the old belt [E] from the bottom, center, then the top.
NOTE: 1) Make sure the ribbed side of the new belt and pawl [F] are facing down.
2) Make sure the new belt is engaged at all three rollers.
[E]
[F]
[D]
x 2).
x 1,
x 1, spring x 1).
B706-9
06/09
Replacement and Adjustment
x 1, clamp x 1).
x 6).
[A]
B478R524.WMF