Toshiba e-STUDIO4500c Service Manual page 550

SERVICE PROGRAM TABLES
2526 LEdge Cor:Thk:FC
This SP sets the coefficient used to 1) correct bias at the leading edge for full-color
image transfer (ITB) bias at image to paper transfer when using thick paper
(128~256 g/m
Notes: These settings apply:
Only the distance from the leading edge set with SP2527.
Only to full color printing on thick paper at half speed.
001 ITB
007 Side1:PTR
008 Side1:SepDC
009 Side1:SepAC
012 Side2:PTR
013 Side2:SepDC
014 Side2:SepAC
2527 LEdge SWT:Thk:FC
This SP sets switch timing that sets the distance from the leading edge where the
settings of SP2526 001 are to apply. The value selected is the number of mm from
the leading edge of the paper. These settings 1) apply only full-color printing on thick
paper (128~256 g/m
001 ITB
002 PTR
003 SepDC
004 SepAC
2528 TEdge Cor:Thk FC
This SP sets the coefficient used to correct bias at image to paper transfer for each
side of the paper. These settings are applied to the trailing edge for full-color printing
on thick paper (128~256 g/m
effect.
007 Side1:PTR
012 Side2:PTR
2529 TEdge Cor:Thk:FC – PTR
002 This setting sets the start timing for application of SP2528 007, 2528 012 at the
trailing edge of each sheet (Side 1, Side 2). These settings are applied to the trailing
edge for black printing on plain paper at full speed and apply to black, even when
printing in full color mode.
[-100~0/1 mm]
The mm distance is measured away from the trailing edge of the image.
Leading Edge Correction for Thick Paper: K
2
), and 3) correct the dc and ac voltages applied at paper separation.
[0~400/1%]
[0~400/1%]
[0~400/1%]
[0~400/1%]
[0~400/1%]
Leading Edge Switch Timing for Thick Paper: FC
2
) at half speed, and 2) apply to to both sides of a duplex page.
[0~30/1 mm]
[0~30/1 mm]
[0~30/1 mm]
Trailing Edge Correction for Thick Paper: FC
2
) at half speed as far as where SP2529 002 takes
[0~400/1%]
Trailing Edge Correction for Thick Paper: FC
5-58
April, 2007