Toshiba e-STUDIO4500c Service Manual page 946

August 2006
At the beginning of the job, the jogger fence motor (M15) [A] switches on and
moves the jogger fences [B] to the standby position (7.5 mm from the sides of the
selected paper size).
When each sheet passes the pre-stack tray exit sensor (S2) and enters the
stapling tray:
The jogger fence motor switches on and moves the jogger fences to within 5.5
mm of the sides of the selected paper size.
The positioning roller solenoid (SOL3) switches on for the time prescribed for the
paper size. This pushes the positioning roller [C] onto the sheet and pushes it
down onto bottom fence. This aligns the edge of the stack.
Next, the jogger fence motor:
Switches on again and moves the jogger fences to within 2.6 mm of the sides of
the stack to align the sides of the stack.
Reverses and moves the fences to the standby position (7.5 mm away for the
sides) and waits for the next sheet.
The jogger fence HP sensor [D] switches off the jogger motor at the end of the
job.
After the last sheet feeds:
The stapling edge pressure plate solenoid [E] (SOL4) switches on and pushes
the pressure plate [F] onto the stack to press down the edge for stapling.
The corner stapler staples the stack.
B700-45
CORNER STAPLING