Handling Dimms And Sd Cards; Dimms - Toshiba e-STUDIO4500c Service Manual

MFP CONTROLLER OPTIONS

1.15.4 HANDLING DIMMS AND SD CARDS

WARNING!
Always turn the machine off and disconnect the machine power cord
before you install a controller option.
Important!
To prevent damage to the controller box, always do your work carefully. Do not
put your hand or a tool into the box when you remove the controller box or install
an option.
To prevent damage to the circuits on the boards, always touch a metal surface to
remove static charge from your hands before you touch electronic components.

DIMMs

1. Hold the ROM DIMM. The edge connector
[A] must point toward the slot and the notch
[B] in the DIMM must be in the top right
corner.
2. Put the edge connector [C] in the slot at a
30-degree angle from the surface of the
board. If the angle is too low, the upper
contact could bend.
3. Carefully move the outer edge of the ROM
DIMM up and down slightly until it goes into
the connector. Then carefully push it down
level with the controller board.
Important: If the upper contact is pushed in
with force, and becomes bent, the
connection will be defective, and the
machine could stop.
SD cards
To install and remove an SD Card:
SD cards are held in position by a small spring-lock mechanism.
1. To install an SD card, push it into the slot until it stops, then release it.
2. To remove an SD card, push the SD card in carefully to release it, and then
remove it from the slot.
Important: To prevent damage to the SD card or the slot lock, always push the
card in, to release it, before you try to remove it.
1-118
August 2006
[A] [B]
[C]
G338I901.WMF