Toshiba e-STUDIO4500c Service Manual page 571

April, 2007
2903 Env Thresh:K_PCU
This SP sets the threshold value of LL and ML for the current room temperature.
001 Abs Humid:Thresh1
002 Abs Humid:Thresh2
003 Abs Humid:Thresh3
004 Abs Humid:Thresh4
2904 Blade Bend Ctrl
A blade-bend prevention pattern is created with K toner on the ITB between every
copy image to lubricate the ITB cleaning blade so it will not bend or scour the
surface of the ITB. These SPs set 1) pattern creation interval, 2) density of the
pattern, 3) whether the pattern is displayed.
Note: This function is OFF. Changing this setting is normally not required for this
machine.
001 Pattern Interval
002 Pattern Light
003 Page Cnt Disp
2905 Used Toner Mtr 2
The waste toner bottle is provided with a near-full sensor and an auger that evenly
distributes the used toner inside the bottle. To extend the life of the waste toner
distribution motor that rotates this auger, the motor and auger do not operate
continuously. The motor is turned ON only after a prescribed amout of toner has
been consumed.
001 Toner Consumed
002 Waste Tnr M Time
Room Temperature Correction Threshold: PCU
[0~10,000 / 0.01 g/m
[0~10,000 / 0.01 g/m
[0~10,000 / 0.01 g/m
[0~10,000 / 0.01 g/m
Blade Bend Prevention Pattern Control
Sets the number of pages between patterns.
[0~200/1 pg.]
Sets the density of the pattern.
[0~63/1]
Displays the count for the number of blade prevention
patterns.
[0~200/1 pg.]
Used Toner Motor 2 (Waste toner distribution motor)
Control
Sets the amount of toner to be used before the toner
[1~10/1 g]
Sets the amount of time the motor remains ON.
[1~10/1 sec.]
5-79
SERVICE PROGRAM TABLES
3
]
3
]
3
]
3
]