Shipping Retainer Removal - Toshiba e-STUDIO4500c Service Manual

COPIER E-STUDIO4500C/5500C

Shipping Retainer Removal

1. Prepare an open space on the floor for the hopper.
2. Remove the screws of the toner hopper cover [A] (
3. Put your hands under the left and right corners of the toner hopper, and slowly
pull it out on its rails until it stops.
4. Push the lock [B] then pull down the support leg [C].
5. Make sure that the support leg is down and locked.
CAUTION
Always make sure that the support leg is down and locked before
you remove the hopper.
6. Hold the toner hopper using the handles at the top left and right sides. Then lift
the toner hopper off its rails and set it on the floor.
CAUTION
The hopper is heavy! Lift it carefully. Make sure that it disengages
fully from the rails on the left and right, and then set it on the floor.
7. Push the hopper rails into the machine.
NOTE: Push in the rails until approximately an inch is out of the machine. If
you push the rails in fully, you must use a pair of needle-nose (radio)
pliers to pull them out again.
[B]
[C]
1-12
August, 2006
[A]
B132I006A.WMF
x 3).