Reinstalling The Belt - Toshiba e-STUDIO4500c Service Manual

August, 2006

Reinstalling the Belt

1. Remove the ARDF front cover [A]
( 3.18.1)
2. Take out the special tool [B]. (
NOTE: The special tool [B] is attached to
the front side plate. It is used to
adjust the tension on the belt on
both ends of the shaft.
[C]
3. Fit the special tool onto the FRONT.
4. Slowly loosen the front lock screw [C] until you see the tip of the shaft
aligned with the hole
Important
To avoid stripping the threads of the screws, do not apply excessive torque.
5. Remove the special tool and fit it onto the REAR.
NOTE: If the Teflon sleeve has been reattached at [D], remove it. Do not
reattach the sleeve until after adjusting the belt tension. (The special
tool does not fit over the rear end with the Teflon sleeve attached.)
6. Slowly loosen the rear lock screw [E] until you see the tip of the shaft
with the hole
7. Re-install the Teflon sleeve.
8. Re-install the front and rear plastic cover.
9. Reinstall the transport belt assembly in the ARDF.
x1)
FRONT REAR
, then tighten the screw.
then tighten the screw.
[A]
3-171
ARDF
[B]
B132R104A.WMF
[D]
[E]
B132R140.WMF
aligned