Initializing Developer And Toner - Toshiba e-STUDIO4500c Service Manual

August, 2006

Initializing Developer and Toner

1. At the left rear corner of the machine, make
sure that the manual breaker switch [A] is
UP.
Important: When the breaker switch is UP,
the copier is ready to be turned on. The "|"
mark can be seen.
Important: Before you turn the copier on,
make sure that the ARDF [B] is connected
to the copier at the left rear corner.
2. Connect the power cord of the copier to a
power outlet.
3. Open the front door [C].
Very Important!:
T
URN ON THE MACHINE WITH THE FRONT
DOOR OPEN TO PREVENT THE MACHINE
FROM PERFORMING THE INITIAL PROCESS
-
CONTROL SELF CHECK
I
F THE FRONT DOOR IS NOT OPEN
DRUMS WILL TURN WITH NO TONER IN THE
PCU .
S
I
F THE POWER IS TURNED
FRONT COVER CLOSED
REPLACEMENT WILL BE REQUIRED
I
F THE DRUMS TURN WITH NO TONER IN THE
PCU ,
S THIS CAN CAUSE THE CLEANING
BLADES TO CATCH ON A DRY DRUM AND
DAMAGE THE DRUM SURFACES
4. With the front door open, turn on the main power switch.
[B]
.
,
THE
ON
WITH THE
,
DEVELOPER
.
.
1-31
COPIER E-STUDIO4500C/5500C
[A]
[C]
Open the Door Before Power ON!
B132I719.WMF
B132I720.WMF
B132I721.WMF