Toshiba e-STUDIO4500c Service Manual page 568

SERVICE PROGRAM TABLES
2876 LEdge Cor:Sp3 FC
These SPs do the following settings when printing on Special Paper 3 in the full-
color mode:
1) ITB: Sets strength/timing of the correction coefficient for the application of bias
when the image is transferred from the drum to the ITB.
2) PTR: Sets the strength/timing of thecorrection coefficient for the application of
bias when the image is transferred from ITB.
3) SepDC, SepAC: Set the strength/timing of the dc and ac charges applied to
neutralize the charges on the belt and paper so they will separate more easily.
Note: SP2876 selects the strength of the bias coefficient, and SP2877 sets the start
timing of the bias application.
001 ITB
007 Side1:PTR
008 Side1:SepDC
009 Side1:SepAC
012 Side2:PTR
013 Side2:SepDC
014 Side2:SepAC
2877 LEdge SWT:Sp3 FC
Sets the switch OFF timing of SP2876. The selected value is the number of mm
from the leading edge. Applies only to printing in full-color mode on Special Paper
3.
001 ITB
002 PTR
003 SepDC
004 SepAC
2878 TEdge Cor:Sp3 FC – PTR
Sets the strength of the bias coefficient for the bias applied at the trailing edge
when the image is transferred from ITB to paper. Applied when printing in full-color
mode on Special Paper 3.
007 Side1:PTR
012 Side2:PTR
2879 TEdge SWT:Sp3 FC –
PTR
Sets the switch timing that determines the distance from the leading edge where
the SP2878 settings are applied during image transfer from ITB to paper. Applied
only when printing in full-color mode on Special Paper 3.
[-100~0/1 mm]
Leading Edge Correction for Special Paper 3: FC
[0~400/5%]
Leading Edge Switch Timing for Special Paper 3: FC
[0~30/1 mm]
Trailing Edge Correction for Special Paper 3: FC
[0~400/5%]
Switch Timing for Special Paper 3: FC
5-76
April, 2007