Brocade Communications Systems StoreFabric SN6500B User Manual page 543

5. To add a new ACL rule, complete
6. To delete an existing ACL rule, select the rule you want to edit in the ACL Entries list and click
7.
8. Click OK on the Device_Name - Layer 2 ACL Configuration dialog box.
Assigning a Layer 2 ACL configuration to an interface (Fabric OS)
To assign Layer 2 ACL configuration to a interface, complete the following steps.
1. Select Configure > Security > Layer 2 ACL > Port.
2. Select a port or Link Aggregation Group (LAG) in the Available Ports list and click the right arrow
3. Click OK.
Brocade Network Advisor SAN User Manual
53-1002696-01
configuration (Fabric OS)"
The new ACL entry displays in the ACL Entries list. To add additional ACL entries, repeat
the left arrow button.
Click OK on the Duplicate - Layer 2 ACL Configuration dialog box.
The new ACL displays in the ACL Entries list. To copy additional ACLs, repeat
step 7.
The Deploy to Products - Layer 2 ACL dialog box displays. To save the configuration, refer to
"Saving a security configuration deployment"
The Port Selection - Layer 2 ACL dialog box displays.
button.
LAGs display in the Available Ports list using the following convention: Po LAG_Number.
The Device_Name - Port_Number/LAG LAG_Number- Layer 2 ACL Configuration dialog box
displays.
FIGURE 174 Device_Name
Layer 2 access control list management
step 4 through step 12
on page 492.
on page 500
Port_Number
- - Layer 2 ACL Configuration dialog box
in "Creating an extended Layer 2 ACL
step 2
17
step 5.
through
495