20
Configuring hosts for encryption targets
FIGURE 292
14. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
Configuring hosts for encryption targets
Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.
NOTE
Hosts are normally selected as part of the Configure Switch Encryption wizard, but you can also edit
hosts later using the Encryption Target Hosts dialog box.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
648
Next Steps screen
The screen contains the following information:
•
Important Instructions: Instructions about post-configuration tasks you must complete
after you close the wizard. For example, you must zone the physical hosts and the target
together and then you encrypt the LUNs using the Storage Device LUNs dialog box.
•
Copy to Clipboard button: Saves a copy of the instructions.
•
Print button: Prints the configuration.
then click Finish to exit the Configure Switch Encryption wizard.
dialog box (Refer to
Figure 185
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar.
on page 526).
Brocade Network Advisor SAN User Manual
53-1002696-01