25
Configuring FICON display
Configuring FICON display
You can set display settings for FICON display so that the columns of any table that contains end
device descriptions to move the following eight columns to be the first columns: FC Address, Serial
#, Tag, Device Type, Model, Vendor, Port Type, and WWN. For instructions, refer to
settings"
Configuring an Allow/Prohibit Matrix
The Allow/Prohibit Matrix is a FICON port attribute that can be used to prohibit communication
between specific ports. Prohibits are not recommended on E_Ports (inter switch links).
The Allow/Prohibit Matrix can be manipulated by host-based management programs using FICON
CUP, or from a Management program to create policies and determine paths for data and
command flows. Up to 8 Allow/Prohibit matrices can be modified at the same time. Allow/Prohibit
Matrix settings apply per switch rather than per fabric, and only work when an active zone
configuration is present in the fabric.
Multiple configurations may be defined, edited, copied, or removed. Only one configuration may be
active per switch.
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
1. Select Configure > Allow/Prohibit Matrix.
2. Select a switch from Available Switches.
3. Choose one of the following options:
832
FIGURE 374
Cascaded configuration, three domains, but only two in a path
on page 84.
The Configure Allow/Prohibit Matrix dialog box displays.
Two default configurations (Active and IPL) are displayed in a tree structure below the switch.
Existing configurations are also displayed.
"SAN display
Brocade Network Advisor SAN User Manual
53-1002696-01