Establishing Teka Key Vault Credentials On The Switch - Brocade Communications Systems StoreFabric SN6500B User Manual

20
Steps for connecting to a TEKA appliance
9. Select the group brocade from the group pull-down menu, then click Add Client.

Establishing TEKA key vault credentials on the switch

The credentials established for the TEKA client must be presented to TEKA by the switch.
1. From the Encryption Center Devices table, select a switch, then select Switch > Key Vault
FIGURE 203
2. Repeat the procedure for each node.
3. Copy the user name and password used when creating the TEKA client.
4. Click OK.
568
A TEKA client user is created and is listed in the table.
Credentials from the menu task bar.
The Key Vault Credentials dialog box displays
Key Vault Credentials dialog box
The dialog box contains the following information:
•
Primary Key Vault selector: Preselected.Preselected. ESKM/SKM key vaults are clustered,
so only one set of credentials is needed.
•
Secondary Key Vault selector: Active only if you are using a TEKA key vault.
•
User Name: Used for creating the client account on the key vault.
•
User Group Name: Used for creating the client account on the key vault.
•
Password: Enter a password for the group leader.
•
Re-type Password: Re-enter the password for verification.
You may create different credentials, but if you do, you must change the TEKA client
credentials to match the new credentials.
The following rules apply for TEKA:
•
The key vault user name and user group name are generated on the switch. To view those
values, select Switch > Properties, then click Key Vault User Name.
•
The generated user name and user group name are registered with TEKA and are used for
administering TEKA clients.
•
The password is established when the TEKA client is created.
(Figure 203).
Brocade Network Advisor SAN User Manual
53-1002696-01