Server Port Settings - Brocade Communications Systems StoreFabric SN6500B User Manual

4. Click Test.
5. Click OK on the message.
6. Click OK to close the Options dialog.

Server port settings

You can configure the server port settings so that you can assign a web server port number and set
the server port to be SSL-enabled.
Configuring the server port
To configure server settings, complete the following steps.
1. Select Server > Options.
2. Select Server Port in the Category list.
3. Enter a port number in the Web Server Port # (HTTPS) field.
4. Enable HTTP redirection to HTTPS by selecting the Redirect HTTP Requests to HTTPS check
Brocade Network Advisor SAN User Manual
53-1002696-01
•
If you are using the external FTP server, select the Use external FTP/SCP/SFTP Server
option.
For step-by-step instructions about configuring the built-in server, refer to
external FTP, SCP, or SFTP server"
An "FTP, SCP, or SFTP Server running successfully" or an error message displays.
If you receive an error message, make sure your credentials are correct, the server is running,
the remote directory path exists, and you have the correct access permission; then try again.
The Options dialog box displays.
The Server Port pane displays
FIGURE 44
Options dialog box (Server Port pane)
The default is 443.
box.
When you enable HTTP redirection, the server uses port 80 to redirect HTTP requests to
HTTPS. Make sure that port 80 is available before you enable HTTP redirection.
on page 127.
(Figure 44).
Software Configuration
"Configuring an
5
129