Vlan Classifier Configuration; Adding A Vlan Classifier Rule - Brocade Communications Systems StoreFabric SN6500B User Manual

4. If enabled, click the Enable FCoE check box to disable the port's membership on the FCoE
5. When you have finished the configuration, click OK to launch the Deploy to Ports dialog box.
6. Click OK after changing the attributes of the current deployment.
7.

VLAN classifier configuration

The Management application supports VLAN classifier management only on Fabric OS 6.3.1_dcb
and Fabric OS 7.0.0.
VLAN classifier rules are used to define specific rules for classifying untagged packets to selected
VLANs based on protocol and MAC addresses. The classified frames are then tagged with a VLAN
ID.
VLAN classifier rules can be categorized into the following areas:
•
•
VLAN classifiers are created on a per-switch basis.
NOTE
The VLAN Classifiers tab on the Edit Switch dialog box displays only on switches with Fabric OS
versions 7.0.0 and later.

Adding a VLAN classifier rule

The Edit Switch dialog box, VLAN Classifiers tab allows you to create rules and group them into
VLAN classifiers, which can then be applied to access port and LAG VLAN members and converged
port VLAN members.
1. Select Configure > DCB.
2. Select a switch and click Edit.
3. Click the VLAN Classifiers tab on the Edit Switch dialog box.
Brocade Network Advisor SAN User Manual
53-1002696-01
map.
The Deployment Status dialog box launches.
Click Start on the Deployment Status dialog box to save the changes to the selected devices.
802.1Q protocol-based classifier rules
MAC address-based classifier rules
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
The Edit Switch dialog box, VLAN Classifiers tab displays, as shown in
Availables Rules list contains the following information:
•
Rule ID—The rule identifier. Vallid rule ID values are from 1 through 256.
•
Rule Type—Valid rule types are MAC (MAC address-based rule) and Proto (802.1Q
protocol-based rule).
•
Encapsulation—The encapsulation type (Ethv2, nosnaplic, or snaplic). The Encapsulation
column only displays a value when Proto is the rule type.

VLAN classifier configuration

Figure 158. The
16
463