Deploying An Stp Configuration On A Port Vlan - Brocade Communications Systems StoreFabric SN6500B User Manual

26
Spanning Tree Protocol configuration
10. The Force Version list is available only if you selected RSTP. This parameter forces the bridge to
11. Specify an interval in the Re-enable Port Interval field, available only if you selected RSTP. This
12. Click the Re-Enable Port State check box, which is available only if you selected RSTP, to
13. Select the Path Cost option: Standard or Custom, available only if you selected RSTP. The path
14. Click the right arrow button to move the selected product to the Selected VLANs list.
15. Click OK to launch the Deploy STP dialog box.

Deploying an STP configuration on a port VLAN

The Deploy STP dialog box allows you to view the STP configuration summary and configure
deployment parameters for a selected VLAN.
The Deploy STP dialog box allows you to deploy an STP configuration to target products. Duplicate
action is not supported.
1. Select a deployment option:
2. Select a Save Configuration option:
3. Enter a name in the Name field that will be used to identify the configured VLAN.
4. Click the Schedules check box, which is available if you selected Schedule as a deployment
5. Click the Snapshots check box if you want the Management application to run and save a
6. Click OK to launch the Deployment Status dialog box.
868
send BPDUs in a specific format. You can enter one of the following values:
•
0: The bridge has been forced to operate in STP default mode.
•
1: The bridge has been forced to operate in RSTP default mode.
interval specifies the number of seconds to wait before the port is enabled. The values range
from 10 through 1000000. The default is 300.
enable or disable the timeout mechanism for the port.
cost is the cost of using the port to reach the root bridge. When selecting among multiple links
to the root bridge, STP chooses the link with the lowest path cost and blocks the other paths.
Each port type has its own default STP path cost.
•
Click the Deploy now option if you want to deploy the STP configuration.
•
Click the Save deployment only option if you want to save the STP configuration without
scheduling its deployment.
•
Click the Schedule option if you want to schedule the deployment of the STP configuration.
•
Click the Save to running option to save the configuration while the system is running.
•
Click the Save to running and startup option to save the configuration both while the
system is running and when the system starts up.
•
Click the Save to running and startup then reboot option to save the configuration both
while the system is running and when the system starts up, and then automatically reboot.
option, to select a frequency.
report after this configuration is deployed to the device.
NOTE
Snapshot options are applicable only for IOS products.
Brocade Network Advisor SAN User Manual
53-1002696-01