Brocade Communications Systems StoreFabric SN6500B User Manual page 165

8. Verify the IP address on the Server Configuration Summary screen and click Next.
9. Click Finish on the Start Server screen.
10. Click Yes on the restart server confirmation message.
11. Enter your user name and password.
12. Click Login.
13. Click OK on the Login Banner.
Configuring the application to use dual network cards
Issues with Client-to-Server connectivity can be due to different reasons. Some examples are:
•
•
To make sure that Clients can connect to the Server, you may need to edit the IP configuration
setting in the Options dialog to manually specify the IP address that the Server should use to
communicate to its Clients.
NOTE
The server binds using IPv6 address by default if your Operating System is IPv6-enabled (dual mode
or IPv6 only). The server binds using IPv4 address by default if your Operating System is
IPv4-enabled. Servers running in dual mode allow the client to communicate from both IPv6 and
IPv4 addresses.
To configure the IP address to override the default RMI server host IP address, complete the
following steps.
NOTE
This configuration option replaces the -Djava.rmi.server.hostname value used in previous releases.
1. Select Server > Options.
2. Select Client/Server IP in the Category list to set the IP address.
3. Choose one of the following options in the Server IP Configuration list.
Brocade Network Advisor SAN User Manual
53-1002696-01
The defaults are Administrator and password, respectively.
NOTE
Do not enter Domain\User_Name in the User ID field for LDAP server authentication.
NOTE
When you launch the Management application or navigate to a new view, the SAN tab displays
with a gray screen over the Product List and Topology Map while data is loading.
The computer running the Server has more than one network interface card (NIC) installed.
The computer running the Server is behind a firewall that performs network address
translation.
The Options dialog box displays.
•
Select All. Go to step
•
Select a specific IP address. Continue with
•
Select localhost. Continue with
4.
step
step 5.
Software Configuration
5.
5
117