Understanding Configuration Status Results - Brocade Communications Systems StoreFabric SN6500B User Manual

15. Click Next.
FIGURE 274
16. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
17. Refer to

Understanding configuration status results

After configuration of the encryption group is completed, the Management application sends API
commands to verify the switch configuration. The CLI commands are detailed in the encryption
administrator's guide for your key vault management system.
1. Initialize the switch. If the switch is not already in the initiated state, the Management
2. Create an encryption group on the switch. The Management application creates a new group
Brocade Network Advisor SAN User Manual
53-1002696-01
All configuration items have green check marks if the configuration is successful. A red stop
sign indicates a failed step. A message displays below the table, indicating the encryption
switch was added to the group you named, and the public key certificate is stored in the
location you specified.
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration.
The Next Steps dialog box displays
certificates for the encryption switch are displayed.
Next Steps dialog box
then click Finish to exit the Configure Switch Encryption wizard.
"Understanding configuration status
application performs the cryptocfg
using the cryptocfg create
--
cryptocfg set keyvault command.
-- -
Creating a new encryption group
(Figure 274). Instructions for installing public key
results".
initnode command.
--
encgroup command, and sets the key vault type using the
-
20
629