11. Click Next.
FIGURE 267
12. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to
Configuring key vault settings for Key Management Interoperability
Protocol (KMIP)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 592.
NOTE
Before selecting KMIP as the key vault type, ensure that all nodes in an encryption group are running
Fabric OS 7.1.0 or later.
Brocade Network Advisor SAN User Manual
53-1002696-01
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration.
The Next Steps dialog box displays
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
Next Steps dialog box
"Understanding configuration status results"
Creating a new encryption group
(Figure
267). Instructions for installing public key
on page 629.
"Creating a new encryption group"
20
623