Brocade Communications Systems StoreFabric SN6500B User Manual page 171

3. To connect using HTTP, complete the following steps.
4. To connect using HTTPS (HTTP over SSL), complete the following steps.
5. (Fabric OS and Network OS products only) Select IPv4 or IPv6 to set the preferred IP format.
6. Click Apply or OK to save your work.
7.
Configuring the preferred IP format
To configure the preferred IP format for the Management application server to connect with
Fabric OS and Network OS devices, complete the following steps.
1. Select Server > Options.
2. Select Product Communication from the Software Configurations list in the Category pane.
3. (Fabric OS and Network OS products only) Select IPv4 (default) or IPv6 to set the preferred IP
4. Click Apply or OK to save your work.
5. Click OK on the "changes take effect after application restart" message.
Brocade Network Advisor SAN User Manual
53-1002696-01
FIGURE 40
Options dialog box (Product Communication pane)
a. Select the Connect using HTTP option.
b. Enter the connection port number in the Port # field. Go to
The default HTTP port number is 80.
NOTE
To manage FIPS-enabled Fabric OS fabrics, you must configure Product Communication using
the Connect using HTTPS (HTTP over SSL) only option.
a. Select the Connect using HTTPS (HTTP over SSL) only option.
b. Enter the connection port number in the Port # field. Continue with
The default HTTPS port number is 443.
Changes to this option take effect after an application restart.
Click OK on the "changes take effect after application restart" message.
The Options dialog box displays.
The Product Communication pane displays
format.
Changes to this option take effect after an application restart.
Software Configuration
step 5.
(Figure 40).
5
step 5.
123