Enabling And Disabling The Encryption Engine State From Properties; Viewing And Editing Encryption Group Properties - Brocade Communications Systems StoreFabric SN6500B User Manual

20

Viewing and editing encryption group properties

FIGURE 327
4. Enter or browse to the file containing the signed certificate, then click OK.

Enabling and disabling the encryption engine state from properties

To enable the encryption engine, complete the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select an encryption engine from the Encryption Center Devices table, then select Engine >
3. In the Encryption Engine Properties table, locate Set State To.
4. Click the adjacent Engine field and select Enabled or Disabled accordingly, then click OK.
Viewing and editing encryption group properties
Whenever you add or change a key vault address, you must also load the corresponding key vault
certificate. When adding or changing a key vault, if the switches in the encryption group have not
been previously registered with the new key vault, you must add the switch certificates to the key
vault.
To view encryption group properties, complete the following steps.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a group from the Encryption Center Devices table, then select Group > Properties from
3. You can also select a group from the Encryption Center Devices table, then click the Properties
696
Import Signed Certificate dialog box
The file is imported onto the switch.
dialog box (Refer to Figure 185
Properties from the menu task bar, or right-click a switch or encryption engine and select
Properties.
NOTE
You can also select a an engine from the Encryption Center Devices table, then click the
Targets icon.
dialog box (Refer to Figure 185
the menu task bar.
icon.
NOTE
If groups are not visible in the Encryption Center Devices table, select View > Groups from the
menu task bar.
on page 526).
on page 526).
Brocade Network Advisor SAN User Manual
53-1002696-01