2. Perform one of the following tasks:
Adding an FCoE login group
Complete the following steps to add switches to a login group. You can manually add ports by
entering the world wide name (WWN) or select available managed CNAs from all discovered hosts.
Only directly-connected devices are supported.
1. Select Configure > FCoE from the menu bar.
2. Click Add.
Brocade Network Advisor SAN User Manual
53-1002696-01
FIGURE 168
FCoE Configuration dialog box
Under Login Group:
•
Click Add to launch the Add Login Group dialog box, where you can select an existing
switch or enter the WWN of a switch on which the FCoE login group will be created. See
"Adding an FCoE login group"
•
Click Edit to launch the Edit Login Group dialog box, where you can edit the login group
parameters. See
"Editing an FCoE login group"
•
Click Delete to remove the login group from the list. See
groups"
on page 484.
or
Right-click the DCB device and select FCoE.
The Add Login Group dialog box displays, as shown in
on page 481.
on page 483.
Figure
FCoE login groups
"Deleting one or more FCoE login
169.
16
481