Brocade Communications Systems StoreFabric SN6500B User Manual page 348

11
AAA Settings tab
Configuring an LDAP server
To add or edit a LDAP server, complete the following steps.
1. Select the AAA Settings tab.
2. Select LDAP Server from the Primary Authentication list.
3. Choose one of the following options:
4. Enter the LDAP server's hostname in the Network address field.
5. Enable security by selecting the Security Enabled check box.
6. Enter the TCP port used by the LDAP server in the TCP Port field.
7.
8. Enter the number of attempts to be made to reach a server before assuming it is unreachable
9. Click OK to return to
300
•
Click Add.
•
Select an existing LDAP server and click Edit.
The Add or Edit LDAP Server dialog box displays
FIGURE 108 Add or Edit LDAP server
If DNS is not configured in your network, provide an IP address instead of the hostname.
When you enable security, the TCP port number automatically changes to port 636 and you
must enable certificate services on the LDAP server.
Default is 389 if security is not enabled. Default is 636 if security is enabled.
Enter the timeout timer value (in seconds) that specifies the amount of time to wait between
retries when the server is busy in the Timeout (Sec) field.
Default is 3 seconds.
in the Attempts field.
Default is 3 attempts.
step 4
(Figure
on the AAA Settings tab.
108).
Brocade Network Advisor SAN User Manual
53-1002696-01