Creating A New Encryption Group - Brocade Communications Systems StoreFabric SN6500B User Manual

20

Creating a new encryption group

•
•
Creating a new encryption group
The following steps describe how to start and run the encryption setup wizard and create a new
encryption group.
NOTE
When a new encryption group is created, any existing tape pools in the switch are removed.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
FIGURE 230
2. Select a switch from the <NO GROUP DEFINED> encryption group. (The switch must not be
3. Select Encryption > Create/Add to Group, from the menu task bar.
The Configure Switch Encryption wizard welcome screen displays
you to create a new encryption group, or add an encryption switch to an existing encryption group.
The wizard also enables you to configure switch encryption.
592
Switch KAC certificates have been signed by a CA and stored in a known location.
Key management system (key vault) certificates have been obtained and stored in a known
location.
dialog box (Figure 230).
Encryption Center dialog box - No group defined
assigned to an encryption group.)
Click Next on each screen to advance to the next step in the wizard. Steps might vary slightly
depending on the key vault type selected, but the basic wizard steps are as follows.
1. Designate Switch Membership.
2. Create a new encryption group or add a switch to an existing encryption group.
3. Select the key vault.
4. Specify the public key filename.
5. Select Security Settings.
(Figure 231). The wizard enables
Brocade Network Advisor SAN User Manual
53-1002696-01