21
LSAN zones
Creating an LSAN zone
1. Select a backbone fabric from the Connectivity Map or Product List.
2. Select Configure > Zoning > LSAN Zoning (Device Sharing).
3. Click the Zone DB tab if that tab is not automatically displayed.
4. Click New Zone.
5. Enter a name for the zone.
6. Press Enter.
7.
8. Review the information in the Activate LSAN Zones dialog box.
9. Click OK to activate the LSAN zones.
10. Click OK to continue.
11. Click OK to close the Zoning dialog box.
Adding members to the LSAN zone
Use this procedure to add a member to an LSAN zone when the member is listed in the Potential
Members list of the Zone DB tab.
1. Select a backbone fabric from the Connectivity Map or Product List.
2. Select Configure > Zoning > LSAN Zoning (Device Sharing).
3. If you want to show all discovered fabrics in the Potential Members list, right-click anywhere in
4. Select one or more LSAN zones to which you want to add members in the Zones list. (Press
5. Select one or more members to add to the zone in the Potential Members list. (Press SHIFT or
740
The Zoning dialog box displays.
The prefix LSAN_ is automatically added in the text field.
For zone name requirements and limitations, refer to
Click Activate.
A message displays informing you that the zones you change will be saved in the zone
database and asking whether you want to proceed. Click Yes to confirm the activation, or click
No to cancel the activation.
All LSAN zones are activated on the selected fabrics and saved to the zone database.
The Zone DB tab of the Zoning dialog box displays.
the table and select Display All.
SHIFT or CTRL and click each zone name to select more than one zone.)
CTRL and click each member to select more than one member.)
"Zone naming conventions"
Brocade Network Advisor SAN User Manual
on page 716.
53-1002696-01