Restoring A Configuration From The Repository - Brocade Communications Systems StoreFabric SN6500B User Manual

12
Configuration repository management

Restoring a configuration from the repository

If you delete a fabric or switch from discovery, the configuration remains in the repository until you
delete it manually. Stored configurations are linked to the switch WWN; therefore, if the IP address
or switch name is changed and then rediscovered, the Switch Configuration Repository dialog box
displays the new switch name and IP address for the old configuration.
NOTE
This feature requires a Trial or Licensed version.
1. Select Configure > Configuration > Configuration Repository.
332
The Switch Configuration Repository dialog box displays.
FIGURE 124
Switch Configuration Repository
The Saved Switch Configurations table displays the following information.
•
Keep check box — Select to keep the associated configuration past the defined age limit.
The configuration will be kept until it is manually deleted, or until the Keep check box is
cleared to enable the age limit again
•
Backup Date/Time — The date and time the last backup occurred. This is the backup that
will be restored.
•
Fabric Name — The name of the fabric to which the selected switch belongs.
•
Name — The name of the switch that will be restored.
•
Configuration Type — The type of configuration for the switch (FC, DCB-running, or
DCB-startup).
•
IP Address — The IP address of the switch that will be restored.
•
WWN — The world wide name of the switch that will be restored.
Brocade Network Advisor SAN User Manual
53-1002696-01