20
Creating a new encryption group
Configuring key vault settings for NetApp Link Key Manager
(LKM/SSKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 592.
Figure 242
FIGURE 242
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault's public key certificate, or browse to
3. If you are using a backup key vault, enter the IP address or host name, and the name of the file
604
shows the key vault selection dialog box for LKM/SSKM.
Select Key Vault dialog box for LKM/SSKM
the desired location.
holding the backup key vault's public key certificate, then click Next.
The Specify Public Key Certificate (KAC) File Name dialog box displays
"Creating a new encryption group"
(Figure
243).
Brocade Network Advisor SAN User Manual
53-1002696-01