Qos Map Policed-Dscp - HP Bc1500 - BladeSystem - Blade PC Reference Manual

QoS Commands

qos map policed-dscp

The qos map policed-dscp Global Configuration mode command modifies the policed-DSCP
map for remarking purposes. To return to the default map, use the no form of this command.
Syntax
qos map policed-dscp dscp-list to dscp-mark-down
no qos map policed-dscp
Parameters
■
dscp-list — Specifies up to 8 DSCP values separated by a space. (Range: 0-63)
■
dscp-mark-down — Specifies the DSCP value to mark down. (Range: 0-63)
Default Setting
The default map is the Null map, which means that each incoming DSCP value is mapped to the
same DSCP value.
Command Mode
Global Configuration mode.
Command Usage
DSCP values 3,11,19... cannot be remapped to other values. The mapping of the IP DSCP to
priority queue is set on a per system basis. If this mode is active, a non-IP packet is always
classified to the best effort queue.
Example
The following command fails to mark down incoming DSCP value 3 as DSCP value 43 on the
policed-DSCP map.
Console(config)# qos map policed-dscp 3 to 43
Reserved DSCP. DSCP 3 was not configured.
18-24 www.hp.com HP PC Blade Switch CLI Reference Guide