show ports storm-control
The show ports storm-control User EXEC mode command displays the storm control
configuration.
Syntax
show ports storm-control [interface]
Parameters
■
interface — A valid Ethernet port. (Full syntax: port)
Default Setting
This command has no default configuration.
Command Mode
User EXEC mode.
Command Usage
There are no user guidelines for this command.
Example
The following command displays the storm control configuration.
Console# show ports storm-control
Port
----
1/e1
2/e1
3/e1
HP PC Blade Switch CLI Reference Guide
State
Rate [Kbits/Sec]
--------
----------------
Enabled
70
Enabled
100
Disabled
100
www.hp.com
Ethernet Configuration Commands
Included
--------------------------------------
Broadcast, Multicast, Unknown Unicast
Broadcast
Broadcast
8-23