Channel-Group - HP Bc1500 - BladeSystem - Blade PC Reference Manual

channel-group

The channel-group Interface Configuration (Ethernet) mode command associates a port with a
port-channel. To remove a port from a port-channel, use the no form of this command.
Syntax
channel-group port-channel-number mode {on | auto}
no channel-group
Parameters
■
port-channel_number — Specifies the ID of the valid port-channel for the current port to
join.
■
on — Forces the port to join a channel without an LACP operation.
■
auto — Allows the port to join a channel as a result of an LACP operation.
Default Setting
The port is not assigned to a port-channel.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
There are no user guidelines for this command.
Example
The following command forces port 1/e1 to join port-channel 1 without an LACP operation.
Console(config)# interface ethernet 1/e1
Console(config-if)# channel-group 1 mode on
HP PC Blade Switch CLI Reference Guide www.hp.com
Port Channel Commands
16-3