ip internal-usage-vlan
The ip internal-usage-vlan Interface Configuration mode command reserves a VLAN as the
internal usage VLAN of an interface. To return to the default configuration, use the no form of
this command.
Syntax
ip internal-usage-vlan vlan-id
no ip internal-usage-vlan
Parameters
■
vlan-id — Specifies the ID of the internal usage VLAN.
Default Setting
The software reserves a VLAN as the internal usage VLAN of an interface.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
■
An internal usage VLAN is required when an IP interface is configured on an Ethernet port
or port-channel.
■
This command enables the user to configure the internal usage VLAN of a port. If an internal
usage VLAN is not configured and the user wants to configure an IP interface, an unused
VLAN is selected by the software.
■
If the software selected a VLAN for internal use and the user wants to use that VLAN as a
static or dynamic VLAN, the user should do one of the following:
■
Remove the IP interface.
■
Use this command to explicitly configure a different VLAN as the internal usage VLAN.
■
Create the VLAN and recreate the IP interface.
Example
The following command reserves an unused VLAN 1236 as the internal usage VLAN of ethernet
port 1/e8.
Console(config)# interface ethernet 1/e8
Console(config-if)# ip internal-usage-vlan 1236
HP PC Blade Switch CLI Reference Guide
www.hp.com
VLAN Commands
28-15