Show Fiber-Ports Optical-Transceiver - HP Bc1500 - BladeSystem - Blade PC Reference Manual

PHY Diagnostics Commands

show fiber-ports optical-transceiver

The show fiber-ports optical-transceiver Privileged EXEC command displays the optical
transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [interface] [detailed]
Parameters
■
interface — A valid Ethernet port. (Full syntax: port)
■
detailed — Detailed diagnostics.
Default Setting
This command has no default configuration.
Command Mode
Privileged EXEC mode
Command Usage
To test optical transceivers, ensure a fiber link is present.
Examples
The following commands display the optical transceiver diagnostics.
Console# show fiber-ports optical-transceiver
Port Temp
---- ----
1/g1 W
1/g2 OK
1/g3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
15-4
Voltage Current
------- -------
OK E
OK OK
www.hp.com
Power
Output Input
------ -----
OK OK
OK OK
HP PC Blade Switch CLI Reference Guide
TX Fault LOS
------- ---
OK OK
E OK