Switchport General Ingress-Filtering Disable - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
VLAN Commands
switchport general ingress-filtering disable
The switchport general ingress-filtering disable Interface Configuration mode command
disables port ingress filtering. Ingress filtering discards frames to VLAN where port does not
belong. To return to the default configuration, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Parameters
There are no parameters for this command.
Default Setting
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
The following commands disable port ingress filtering on Ethernet port 1/e16.
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general ingress-filtering disable
28-12
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
