Arp - HP Bc1500 - BladeSystem - Blade PC Reference Manual

arp

The arp Global Configuration mode command adds a permanent entry in the Address Resolution
Protocol (ARP) cache. To remove an entry from the ARP cache, use the no form of this
command.
Syntax
arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel port-channel
number}
no arp ip_addr {ethernet interface-number | vlan vlan-id | port-channel port-channel number}
Parameters
■
ip_addr — Valid IP address or IP alias to map to the specified MAC address.
■
hw_addr — Valid MAC address to map to the specified IP address or IP alias.
■
interface-number — Valid Ethernet port.
■
vlan-id — Valid VLAN number
■
port-channel number. — Valid port-channel number.
Default Setting
This command has no default configuration.
Command Mode
Global Configuration mode
Command Usage
The software uses ARP cache entries to translate 32-bit IP addresses into 48-bit hardware
addresses. Because most hosts support dynamic resolution, static ARP cache entries do not
generally have to be specified.
Example
The following command adds IP address 198.133.219.232 and MAC address 00:00:0c:40:0f:bc
to the ARP table.
Console(config)# arp 198.133.219.232 00:00:0c:40:0f:bc ethernet 1/e6
HP PC Blade Switch CLI Reference Guide
.
www.hp.com
IP Addressing Commands
11-5