Wrr-Queue Cos-Map - HP Bc1500 - BladeSystem - Blade PC Reference Manual

wrr-queue cos-map

The wrr-queue cos-map Global Configuration mode command maps Class of Service (CoS)
values to a specific egress queue. To return to the default configuration, use the no form of this
command.
Syntax
wrr-queue cos-map queue-id cos1...cos8
no wrr-queue cos-map [queue-id]
Parameters
■
queue-id — Specifies the queue number to which the CoS values are mapped.
■
cos1...cos8 — Specifies CoS values to be mapped to a specific queue. (Range: 0-7)
Default Setting
Default cos to queue map
Command Mode
Global Configuration mode
Command Usage
This command can be used to distribute traffic into different queues, where each queue is
configured with different Weighted Round Robin (WRR) and Weighted Random Early Detection
(WRED) parameters.
It is recommended to specifically map a single VPT to a queue, rather than mapping multiple
VPTs to a single queue. Use the priority-queue out num-of-queues Interface Configuration
(Ethernet, Port-channel) mode command to enable expedite queues.
Example
The following command maps CoS 7 to queue 2.
Console(config)# wrr-queue cos-map 2 7
HP PC Blade Switch CLI Reference Guide www.hp.com
QoS Commands
18-17