Set - HP Bc1500 - BladeSystem - Blade PC Reference Manual

set

The set Policy-map Class Configuration mode command sets new values in the IP packet.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos}
no set
Parameters
■
new-dscp — Specifies a new DSCP value for the classified traffic. (Range: 0-63)
■
queue-id — Specifies an explicit queue ID for setting the egress queue.
■
new-cos — Specifies a new user priority for marking the packet. (Range: 0-7)
Default Setting
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
Command Usage
This command is mutually exclusive with the trust Policy-map Class Configuration command
within the same policy map.
Policy maps that contain set or trust Policy-map Class Configuration commands or that have
ACL classifications cannot be attached to an egress interface by using the service-policy
(Ethernet, Port-channel) Interface Configuration mode command.
To return to the Policy-map Configuration mode, use the exit command. To return to privileged
EXEC mode, use the end command.
Example
The following command sets the DSCP value in the packet to 56 for classes in in policy map
called policy class map class1.
Console (config)# policy-map policy1
Console (config-pmap)# class
Console (config-pmap-c)# set dscp 56
HP PC Blade Switch CLI Reference Guide
class1
www.hp.com
QoS Commands
18-11