switchport general pvid
The switchport general pvid Interface Configuration mode command configures the PVID
when the interface is in general mode. To return to the default configuration, use the no form of
this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
Parameters
■
vlan-id — Specifies the PVID (Port VLAN ID).
Default Setting
If the default VLAN is enabled, PVID = 1. Otherwise, PVID=4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
The following commands configure the PVID for Ethernet port 1/e16, when the interface is in
general mode.
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general pvid 234
HP PC Blade Switch CLI Reference Guide
www.hp.com
VLAN Commands
28-11