Address Table Commands
bridge multicast forward-all
The bridge multicast forward-all Interface Configuration (VLAN) mode command enables
forwarding all multicast packets on a port. To restore the default configuration, use the no form
of this command.
Syntax
bridge multicast forward-all {add | remove} {ethernet interface-list | port-channel
port-channel-number-list}
no bridge multicast forward-all
Parameters
■
add — Force forwarding all multicast packets.
■
remove — Do not force forwarding all multicast packets.
■
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
■
port-channel-number-list — Separate nonconsecutive port-channels with a comma and no
spaces; a hyphen is used to designate a range of port-channels.
Default Setting
This setting is disabled.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
There are no user guidelines for this command.
Example
The following command configures the device to forward all multicast packets on port 1/e8.
Console(config)# interface vlan 2
Console(config-if)# bridge multicast forward-all add ethernet
5-6
1/e8
www.hp.com
HP PC Blade Switch CLI Reference Guide