Connecting Cables; Connecting Network Cable; Installing The Sfp Transceiver Module And Optical Fibers - HP officeconnect 1910 series Getting Started Manual

Connecting cables

Connecting network cable

Use crossover cable or straight through cable to connect a PC or other network devices to the
Ethernet port of the switch.
Figure 12 Connecting network cable

Installing the SFP transceiver module and optical fibers

CAUTION:
• Hold the SFP transceiver module by its two sides when you install or remove the module. Do not
touch the golden finger of the module.
• Remove the optical fiber, if any, from a transceiver module before installing it.
To install an SFP transceiver module and optical fibers:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Pivot the clasp of the module up. Holding the module, gently push the module into the slot until
2.
it has firm contact with the slot (when the top and bottom spring tabs catch in the slot).
Remove the protective sleeves from the optical fibers, and the dust plug from the transceiver
3.
module.
Connect the LC connectors of the optical fibers to the transceiver module.
4.
NOTE:
Keep the protective sleeves for future use.
9