Table of Contents
Advertisement
Front Service Position
To place a drawer in the front service position, do the following:
Attention:
the front service position from the rear of the system.
1. If you have not already done so, open the front door of the rack unit.
2. Loosen the two thumbscrews that attach the front bezel to the drawer.
3. Grasp both sides of the front bezel and pull it off the drawer.
4. Remove the screws that attach the left and right retaining brackets and remove the
brackets.
5. If you have not already done so, open the rear door of the rack unit.
6. If present, remove the two screws securing the drawer to the rack. Refer to "Rear
Service Position" on page 467.
7. Push the drawer forward until it is stopped by the two detents.
468
Service Guide
Do not pull the drawer out from the front. The drawer must be pushed to
Advertisement
Table of Contents
