Figure 107. Replacing and securing the cover
3. Replace the two cover screws, one on each side of the cover.
Service and operating positions for 5104-22C, 9006-22C, or
9006-22P
Learn how to place an system into the service or operating position.
Placing an 5104-22C, 9006-22C, or 9006-22P system into the service
position
To place a system into the service position, complete the steps in this procedure.
Before you begin
Notes:
• When you place the system in the service position, ensure that the cables at the rear of the system do
not catch or bind as you pull the system unit out of the rack.
• When you place the system into the service position, ensure that all stability plates are firmly installed
to prevent the rack from toppling. Ensure that only one system unit is in the service position at a time.
Common procedures for servicing or installing features in the 5104-22C, 9006-22C, or 9006-22P system 127