Table of Contents
Advertisement
Note: If the adapter or device has a problem that prevents it from replacement by
7. Press F4 to display the Device Names menu.
8. Select the adapter you are removing from the menu.
9. Answer YES to Keep Definition. Press Enter.
10. The ARE YOU SURE screen displays. Press Enter to verify the information.
Successful unconfigure is indicated by the OK message displayed next to the
Command field at the top of the screen.
11. Press F3 to return to the PCI Hot-Plug Manager menu.
12. Select Replace/Remove a PCI Hot-Plug Adapter and press Enter. The
Replace/Remove a PCI Hot-Plug Adapter menu displays.
13. Move the cursor to select the adapter that you are removing and press Enter.
14. Press the Tab key until the entry field displays the replace operation and then
Press the Enter key. Follow the instructions that display on the screen until you are
instructed to remove the adapter.
15. When you are instructed to remove the adapter from the adapter slot, disconnect
any cables that are connected to the adapter being removed.
16. Turn the locking latch and lift the plastic stop for the adapter.
17. Carefully grasp the adapter by the edges and pull it straight out from the I/O board.
18. Replace the adapter in the adapter slot. Carefully grasp the adapter by the edges
and align the adapter in the slot guides. Insert the adapter fully into the adapter
slot connector. If you are installing a full-length adapter, ensure that both ends of
the adapter engage the card guides.
19. Lower the plastic stop over the adapter bracket and rotate the locking latch
clockwise until it clicks into the locked position. Some full-length cards can be
supported by rotating the blue adapter latch on the right end of the adapter
counterclockwise.
20. Connect appropriate cables and devices to the adapter.
21. Continue to follow the screen instructions until you receive a message that the
replacement is successful. Successful replacement is indicated by the OK message
displayed next to the Command field at the top of the screen.
22. Press the F3 key to return to the PCI Hot-Plug Manager menu.
23. Select Install/Configure Devices Added After IPL and press Enter. Then follow
the instructions on the screen. Successful replacement is indicated by the OK
message displayed next to the Command field at the top of the screen.
24. If you do not have other adapters to replace, continue with the next step.
OR
If you have other adapters to replace, press the F3 key to return to the PCI
Hot-Plug Manager menu and then return to step 12.
25. Press F10 to exit the Hot-Plug Manager.
434
Service Guide
hot swap, it must be replaced non hot swap by shutting down the system.
Go to the RS/6000 and Eserver pSeries Diagnostics Information for
Multiple Bus Systems Map 210 - 3.
Advertisement
Table of Contents
