Operator Panel
Removal
1. Turn off power as described in "Powering Off the System" on page 429.
2. Place the I/O drawer in the front service position as described in "Front Service
Position" on page 468.
3. Loosen the two retaining screws that attach the front bezel to the drawer.
4. Grasp both sides of the front bezel and pull it off the drawer.
5. Place the drawer in the front service position as described in "Front Service
Position" on page 468.
6. Remove the two screws from the top of the operator panel.
7. Pull the operator panel out.
8. Disconnect the cables from the operator panel.
9. Remove the operator panel from the mounting bracket.
Chapter 9. Removal and Replacement Procedures
465