IBM 7026-H80 - RS/6000 - 256 MB RAM Service Manual page 251

Table 6. Service Processor Error Codes. (continued)
Error Code Description
4069 00A6 Memory test detected no usable
memory
4069 00A7 Memory test detected hardware
problem
4069 00B0 Memory test detected bus controller
lock-unlock failure
4069 00B1 Memory test detected bus controller
failure
4069 00B7 Memory test detected insufficient
hardware resources to continue IPL
4069 0100 Memory test detected memory riser
card fault
4069 0101 Memory test detected memory DIMM
fault
4069 0102 Memory test detected memory DIMM
fault
4069 0103 Memory test detected memory DIMM
fault
4069 0104 Memory test detected memory DIMM
fault
4069 010D Memory test detected memory DIMM
fault
4069 0111 Memory test detected memory DIMM
fault
4069 0112 Memory test detected memory DIMM
fault
4069 0113 Memory test detected memory DIMM
fault
4069 0114 Memory test detected memory DIMM
fault
Action/
Possible Failing FRU
1. Ensure that memory DIMMs and
cards are properly installed
2. Go to service processor memory
configuration/deconfiguration
menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 384 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 113.
Go to "MAP 1540: Minimum
Configuration" on page 113.
RIO adapter
Location: U0.1-P1.1
RIO adapter
Location: U0.1-P1.1
This error code appears after the
initial testing by the service processor
firmware on the CEC was completed
correctly, but a problem occurred
when the firmware tried to
communicate outside the CEC.
Suspect a problem with the RIO
interface, either cables or adapters.
Memory riser card
Location: U1.1-P1-M2
Memory DIMM
Location: U1.1-P1-M2.15
Memory DIMM
Location: U1.1-P1-M2.1
Memory DIMM
Location: U1.1-P1-M2.16
Memory DIMM
Location: U1.1-P1-M2.2
Memory DIMM
Location: U1.1-P1-M2.1 x4
Memory DIMM
Location: U1.1-P1-M2.13
Memory DIMM
Location: U1.1-P1-M2.3
Memory DIMM
Location: U1.1-P1-M2.14
Memory DIMM
Location: U1.1-P1-M2.4
Chapter 5. Error Code to FRU Index
233