IBM 7026-H80 - RS/6000 - 256 MB RAM Service Manual page 283

Table 6. Service Processor Error Codes. (continued)
Error Code Description
406F 00A2 Error code generation/logging
detected service processor Firmware
(processor runtime diagnostics) Fault
406F 00A3 Error code generation/logging
detected memory plugging fault
406F 00A4 Error code generation/logging
detected application caused fault
406F 00A5 Error code generation/logging
detected invalid system configuration
406F 00A6 Error code generation/logging
detected no usable memory
406F 00A7 Error code generation/logging
detected hardware problem
406F 00B0 Error code generation/logging
detected bus controller lock-unlock
failure
406F 00B1 Error code generation/logging
detected bus controller failure
406F 00B7 Error code generation/lgging detected
insufficient hardware resources to
continue IPL
406F 0100 Error code generation/logging
detected memory riser card fault
406F 0101 Error code generation/logging
detected memory DIMM fault
406F 0102 Error code generation/logging
detected memory DIMM fault
Action/
Possible Failing FRU
Check for system firmware update
All pluggable memory.
Go to "MAP 1540: Minimum
Configuration" on page 113 and run
CEC drawer minimum configuration
to isolate the failing memory
component.
Application software
Verify system components are
supported and properly installed
1. Ensure that memory DIMMs and
cards are properly installed.
2. Go to service processor memory
configuration/deconfiguration
menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 384 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 113.
Go to "MAP 1540: Minimum
Configuration" on page 113.
RIO adapter
Location: U0.1-P1.1
RIO adapter
Location: U0.1-P1.1
This error code appears after the
initial testing by the service processor
firmware on the CEC was completed
correctly, but a problem occurred
when the firmware tried to
communicate outside the CEC.
Suspect a problem with the RIO
interface, either cables or adapters.
Memory riser card
Location: U1.1-P1-M2
Memory DIMM
Location: U1.1-P1-M2.15
Memory DIMM
Location: U1.1-P1-M2.1
Chapter 5. Error Code to FRU Index
265