Table of Contents
Advertisement
Hot-Pluggable PCI Adapter
Replacing a Hot-Pluggable PCI Adapter
Note: Use this procedure only when you are replacing an adapter with an identical
To replace an adapter, perform the following steps:
1. Place the I/O drawer in the rear service position:
a. If you have not already done so, open the front door of the rack unit.
b. Loosen the two thumbscrews that attach the front bezel to the drawer.
c. Grasp both sides of the front bezel and pull the bezel off the drawer.
d. If you have not already done so, open the rear door of the rack unit.
e. If present, remove the two retaining screws that secure the drawer to the rails.
f. Ensure that the cables do not restrain drawer movement.
g. Grasp the bar at the rear of the drawer, and pull the drawer to the rear until it
2. Remove the two thumbscrews, and remove the top cover from the drawer.
3. Determine the slot from which you are removing the adapter.
4. Ensure that any processes or applications that might use the adapter are stopped.
Note: Removing a hot-pluggable PCI adapter requires the system administrator to
5. Refer to "PCI Hot-Plug Manager Access" on page 438, and follow the steps in the
access procedure to select PCI Hot Plug Manager. Then return here to continue.
6. Select Unconfigure a Device and press Enter.
adapter. If you are replacing an adapter with an adapter that is not identical to
the adapter removed, go to "Removing a Hot-Pluggable PCI Adapter" on
page 436 and "Installing a Hot-Pluggable PCI Adapter" on page 435.
Refer to "Rear Service Position" on page 467.
is stopped by the detents.
take the PCI adapter offline before performing any PCI adapter hot-plug
procedures. Before taking an adapter offline, the devices attached to the
adapter must be taken offline as well. This action prevents a service
representative or user from causing an unexpected outage for system
users.
For additional information about taking an adapter offline or removing it from
the system configuration, see the AIX System Management Guide:
Operating System and Devices . This publication is available at the following
Web address: http://www-1.ibm.com/servers/aix/library/. Select
Technical Publications. This publication is also contained on the AIX
Documentation CD. The documentation is made accessible by loading the
documentation CD onto the hard disk or by mounting the CD in the
CD-ROM drive.
Chapter 9. Removal and Replacement Procedures
433
Advertisement
Table of Contents
