IBM 7026-H80 - RS/6000 - 256 MB RAM Service Manual page 256

Table 6. Service Processor Error Codes. (continued)
238
Service Guide
Error Code Description
406A 00A2 Self test detected service processor
firmware (processor runtime
diagnostics) fault
406A 00A3 Self test detected memory plugging
fault
406A 00A4 Self test detected application caused
fault
406A 00A5 Self test detected invalid system
configuration
406A 00A6 Self test detected no usable memory
406A 00A7 Self test detected hardware problem
406A 00B0 Self test detected bus controller
lock-unlock failure
406A 00B1 Self test detected bus controller
failure
406A 00B7 Self test detected insufficient
hardware resources to continue IPL
406A 0100 Self test detected memory riser card
fault
406A 0101 Self test detected memory DIMM
fault
406A 0102 Self test detected memory DIMM
fault
406A 0103 Self test detected memory DIMM
fault
Action/
Possible Failing FRU
Check for system firmware update
All pluggable memory.
Go to "MAP 1540: Minimum
Configuration" on page 113 and run
CEC drawer minimum configuration
to isolate the failing memory
component.
Application software
Verify system components are
supported and properly installed
1. Ensure that memory DIMMs and
cards are properly installed.
2. Go to service processor memory
configuration/deconfiguration
menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 384 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 113.
Go to "MAP 1540: Minimum
Configuration" on page 113.
RIO adapter
Location: U0.1-P1.1
RIO adapter bus
Location: U0.1-P1.1
This error code appears after the
initial testing by the service processor
firmware on the CEC was completed
correctly, but a problem occurred
when the firmware tried to
communicate outside the CEC.
Suspect a problem with the RIO
interface, either
Memory riser card
Location: U1.1-P1-M2
Memory DIMM
Location: U1.1-P1-M2.15
Memory DIMM
Location: U1.1-P1-M2.1
Memory DIMM
Location: U1.1-P1-M2.16