Storing The Ip Address And Subnet Mask - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Chapter 5
Unix Ethernet Interface Configuration
NOTE: If you would like to communicate with the Ethernet

Storing The IP Address And Subnet Mask

To store the IP address and subnet mask using the Ethernet
Interface internal command shell, npsh:
NOTE: If you would like to communicate with the Ethernet
112
b. At the "Network Configuration" HTML form that displays,
click in the field below the "IP Address" heading and type in
the IP address for the Ethernet Interface.
c. Under the "Subnet Mask" heading, enter the Ethernet
Interface subnet mask.
Interface from across routers, you will need to fill in an entry
within the "Routing" section. Please see "Communicating
Across Routers" on page 115 for further details.
d. Click the SUBMIT button when done and physically
repower the print server to make sure the new settings are
in effect.
a. Telnet to the Ethernet Interface using the IP address
determined in step 2 above. Log in as root with no
password.
b. At the system prompt, enter the command to store the IP
address: store tcpip 1 addr EthernetInterfaceIPaddress
(e.g., store tcpip 1 addr 192.75.11.9)
c. Now enter the command to store the subnet mask:
store tcpip 1 mask netmask
(e.g., store tcpip 1 mask 255.255.0.0)
Interface from across routers, you will need to specify a
default router using the store tcpip route command as
described in "Communicating Across Routers" on page
115.
d. Repower the printer to have the stored settings to take
effect.