Rprinter/Nprinter Setup - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Chapter 7
Troubleshooting (10/100Base-T)
•
•
If none of these solutions help your situation, try the whole setup
again. Completely delete the setup that is giving you trouble and go
through the setup again, following each step carefully.
NOTE: After completing a PSERVER setup and before beginning

RPRINTER/NPRINTER Setup

If you cannot get a connection with the Ethernet Interface after
completing the print setup, confirm the following:
•
•
•
•
172
If the Ethernet Interface has logged in to the file server but has
not attached to the queue, there may be a permission problem.
Make sure the appropriate users have rights to this queue (they
should be in the group "everyone"). Also, you may have to
assign the queue to root so it is available to everyone.
Did you rename any objects in Netware Administrator during
your setup? Netware Administrator seems to have a problems
renaming objects. If so, delete everything and start over.
a new setup, be sure to reboot the printer. Wait at least a
minute for the Print Server to login and attach to a queue.
Have you tried repowering the printer? Wait about a minute
before checking to see if it has logged in and attached to a
queue.
Is the network connector fastened tightly to the unit?
Is the Ethernet Interface already servicing a queue on another
file server? If so, it cannot service another file server at the
same time.
Is an entry produced when a list rprinter telnet command
is done on the Ethernet Interface (not found on the Novell
HTML status page)? When the Ethernet Interface is configured
as an RPRINTER, this command should produce the
appropriate entry.