Using An Os/2 Lpr Print Queue - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Using An OS/2 LPR Print Queue

This section describes how to set up an OS/2 Warp 4 print queue to
print to the Ethernet Interface using the LPR protocol. TCP/IP for
OS/2 must be installed on your OS/2 workstation. This procedure is
similar to OS/2 Warp 3 and v2.11.
To set up the printer queue:
1. Find the Printer template icon. It may be in the Printers folder or
the Templates folder.
2. Right click on the icon, then select "Install." The "Create a
printer" dialog box displays.
3. Enter any desired name for the printer. This will be the name of
the printer queue.
4. In the "Default printer driver" list, select the desired driver. If the
desired driver does not appear in the list, click on "Install new
printer driver..." and follow the instructions to install the desired
driver.
5. In the "Output port" list, double click an unshaded \PIPE\LPDx
port. If all are shaded, double click a shaded port and change
the parameters. If no \PIPE\LPDx ports displays, follow these
steps to install them:
a. Right click a port and select "Install."
b. Select the "New port drivers" radio button.
c. In the "Directory" field, type d:\TCPIP\DLL where d: is the
drive where the TCPIP subdirectory exists.
d. Click "Refresh." Several \PIPE\LPDx port icons should
appear in the "Output port" list. If none appear, type
d:\MPTN\DLL and repeat this step again.
NOTE: If no ports appear after completing step d, search your
drives for the LPRPDRVR.PDR and type the path to this
file, not including the file name (in step c). The final step
available is to ask OS/2 support to install these ports.
Using An OS/2 LPR Print Queue
179